Panasonic DMR-EZ47VP Service Manual page 17

Error Code Diagnosis contents
F09 Serial Communication
between VHS Microprocessor
and Timer Microprocessor.
F34 Initialization error when main
microprocessor is started up
for program recording
F58 Drive hardware error
F60 DVD module has not been
started.
HDMI HDMI connection check
F74 HDIM Device
Communication error.
F75 HDIM Device Key Information
error
UNSUPPO Unsupported disc error
RT
NO READ Disc read error
HARD Drive error
ERR
No REC Recording is impossible
SELF Restoration operation
CHECK
Description
Error Please confirm Serial
terminal of Microprocessor.
NOTE:
If F09 appears just after updating Firmware,
pull off and insert AC plug, then it will
disappear.
When initialization error is detected after
starting up main microprocessor for program
recording, the power
automatically.
The event is saved in memory.
When drive unit error is detected, the event is
saved in memory.
Defect of Digital P.C.B.
Mode: No change
This unit is confirming that ut is connected
with equipment compatible
control.
Key HDMI connection could not be authenticated
due to a transfer malfunction.
Factor of HDMI Device key-road failure
· When HDMI LSI is damaged.
· When the bus line of I2C doesn´t operate
normally.
· When device key information recorded is
damaged.
HDMI connection could not be authenticated
due to an internal data malfunction.
Factor of HDMI Device key-road failure
· When HDMI LSI is damaged.
· When the bus line of I2C doesn´t operate
normally.
· When device key information recorded is
damaged.
*An unsupported format disc was played,
although the drive starts normally.
*The data format is not supported, although
the media type is supported.
*Exceptionally in case of the disc is dirty.
*A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not be read.
The drive detected a hard error.
[No REC] is displayed when recording is
impossible due to the defect, dirt or wound of
media.
Since the power cord fell out during a power
failure or operation, it is under restoration
operation.
*It will OK, if a display
automatically. If a display does not disappear,
there is the possibility that defective Digital
P.C.B.
Monitor Display
Communication No display
No display
is turned off
No display
No display
No display
with HDAVI
No display
No display
"This disc
incompatible."
"Cannot
Please check the
disc."
"DVD drive error."
No display
No display
disappears
17
DMR-EZ47VP / DMR-EZ475VP
Automatic FL display
No display
No display
is
Display for 5 seconds.
read.
Display for 5 seconds.
"0" is displayed one by one.