Install Overlay Series Custom Panels - Jenn-Air JS42SEFXDB Installation Manual

A B
A. Rear leveling bolt
B. Front leveling bolt
2. Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinetry. The cabinetry surface must be
plumb for the ideal fit of the refrigerator side trim.
3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm) of the
top soffit.
NOTE: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within ¹⁄₄" (6.35 mm) of
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
2" (5 cm)
D
A. Center board ¹⁄₄ " (6.35 mm) max. above refrigerator
B. 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards (2)
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with
the door alignment or top grille fit. To avoid damage to
the cabinet or leveling legs, do not apply more than
50 inch-pounds (5.65 Nm) of torque to the leveling bolts.
The leveling legs can be extended to a maximum of 1¹⁄₄"
(3.18 cm) below the rollers.
4. For Classic and Overlay models, additional adjustments may
be needed after the custom panels are installed.

Install Overlay Series Custom Panels

IMPORTANT:
Install the custom handles prior to installing the panels on the
refrigerator. For more information on Jenn-Air custom handle
selection, refer to the Jenn-Air Catalog, visit
www.jennair.com, or call 1-800-JENNAIR
(1-800-536-6247). In Canada, visit www.jennair.ca, or call
1-800-807-6777.
Create custom door overlay panels according to the
specifications in the "Overlay Series Custom Panels" section.
20
A B
C
¹⁄₄
" (6 mm)
max.
Jenn-Air is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the refrigerator for service.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator and
A
freezer doors.
B
2. Open the refrigerator and freezer compartment doors.
3. Remove the handle side and top trims.
A
4. Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
A
5. Reinstall the handle-side and top trims.
6. Remove the skin from the screw covers. Slide or snap the
screw covers into the handle trim section.
7. Check refrigerator level and alignment. Adjust if needed.
A. Trims
A. Panels
A
A