Dip Switch Settings; Initial Dedicated Power-Up - it SILVER STRIKE BOWLING Installation And Operation Manual

Dip Switch Settings

SW202 Dip Switch Settings
Positions Function
4 3 2 1
0 0 0 0 Default
1 0 0 0 Enter Operator Mode Menus
SW200 Dip Switch Settings
Position Function
4 3 2 1
1 1 1 1 Default - Switch Is Not Used
SW201 Video Dipswitch Settings
Position Video Resolution Scan Rate
4 3 2 1 Mode
0 0 0 1 1 640 X 480
0 0 1 0 2 800 X 600
0 1 0 0 4 340 X 255
0 1 0 1 5 512 X 384
Initial Power-Up
There are several steps you should take when powering up your Silver Strike Bowling for the first time. This is a
quick checklist for you to follow when doing your first initial power-up:
q Plug in the game and turn it ON; be sure the game powers up correctly into the attract mode.
q Adjust volume levels to desired settings.
q
Adjust monitor settings for best picture.
NOTE:
Sound and Video Tests are available through the System Tests Menu. They are beneficial when making
any adjustments. (See System Tests Menu on page 26). Proper monitor and sound adjustment is very
important.
q
Try all money slots. Drop quarters or tokens through to check the coin mechs and insert a bill into the
bill acceptor. Make sure the game is adding credits.
q
Test all of the player input controls. You can use the PLAYER CONTROL TESTS in the SYSTEM
TESTS MENU.
q Upon initial power-up the game is set to factory default settings. These settings affect game elements
such as number of credits per coin, difficulty settings, etc. The OPERATOR MENUS section (see page
21) will describe how to alter these settings for your location.
Congratulations! Your Silver Strike Bowling is ready for play!
Silver Strike Bowling™
© Copyright 2004 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
0 = OFF 1 = ON
0 = OFF 1 = ON
0 = OFF
Monitor
31.5 KHz VGA
37.8 KHz SVG A
15.75 KHz Low Resolution
25 KHz Medium Resolution
Version 08/04
All other marks are the properties of their respective owners. All rights reserved.
1 = ON
Video connection
Direct from Chassis, See Diagram on Page 45
Direct from Chassis, See Diagram on Page 45
Through I/O board, See Diagram on Page 45
Through I/O board, See Diagram on Page 45
Page 19