Vax C85-ID-Be Let's Get Started page 5

Using your machine
CAUTION: When unwinding the power cord do not pull further than the yellow marker.
IMPORTANT: The base of the vacuum cleaner should always be positioned flat on the floor when starting and in use.
The dirt container should be locked into place before lifting the vacuum cleaner by the carry handle.
Unwind the power cord. Plug into mains and push
Do not pull further than the the on/off button to turn
yellow marker. your machine on
Lower brushes for Slide vent cover on hose grip open
hard floors. to reduce suction if required.
Using your tools
Choose an accessory and push onto the
telescopic extension tube or hose.
C85-ID-BePe_ImpactSeries_UG_[VAX01441]_PRINT_29.08.14.indd 8-9
For use on carpets, click Raise brushes for carpets.
rocker switch forward.
For use on hard floors click
rocker switch back.
The TurboTool connector must be fitted
on the hose when using the TurboTool
(some models only).
IMPORTANT: Unplug and switch off vacuum cleaner before performing maintenance or troubleshooting checks.
Emptying and cleaning the dirt container
Press dirt container release button
and lift to remove.
TIP
Tap the shroud over a bin to remove
any dirt/debris.
Taking care of your machine
Hold dirt container over a bin and pull Twist the shroud and pull to remove.
the dirt release clip on the bottom of
the dirt container, allowing dirt/debris
to fall out.
40˚C 40˚C
!
MAX MAX
Rinse the shroud under water
(Max 40°C) Leave to dry for 24 hours
or until fully dry before placing back in
the machine.
TIP
12/09/2014 10:24