Sony MEX-1HD Service Manual page 6

MEX-1HD
Ver 1.1
NOTE FOR THE OPENING OF THE FRONT PANEL
In this set, the front panel is lowered to below the bottom face
when it is opened.
When servicing the set, place it on a stand having a height of about
2 cm.
JIG ON REPAIRING
When repairing this set, connect the extension cables as the figure
shown below.
Connect jig (extension cables J-2502-069-3 :
0.5mm Pitch, 20/40 cores, Length 250mm)
to the mechanism deck and the main board
(CN2002, CN2003).
power board (CN702)
main board (CN2002)
main board (CN2003)
Connect jig (extension cable J-2502-069-2 :
0.5mm Pitch, 50 cores, Length 300mm)
to the main board (CN3002) and
the sub board (CN526).
6
2 cm
stand
main board (CN3002)
mechanism deck
Connect jig (extension cable J-2502-069-1 :
24 cores) to the power board (CN702) and
the sub board (CN525).
sub board (CN525)
sub board (CN526)
front panel section