Tpms Failure Message - Ferrari 2012 F12 Berlinetta Owner's Manual

TPMS failure
The screen page shown in example
circumstances:
- malfunction in the circuit and/or wiring connecting the ECU
- signal is not received by one or more sensors due to a faulty,
broken or flat battery
- fault in the TPMS ECU.
Simultaneously, the specific warning light on the instrument
panel (see page 112) starts flashing, and continues to flash for
90 seconds. The warning light then remains on in fixed mode until
the situation is corrected.
The TYRES screen page cannot be called up by the driver.
System temporarily not active
The screen page shown in example
circumstances:
- overheating of sensors
- during calibration
(the TPMS ECU does not recognise the sensors)
- radio frequency that interferes with the wheel sensor signal.
TPMS failure
16
Safety
70
is displayed in the following
16
17 is displayed in the following
TPMS
temporarily
inactive
17
Simultaneously, the specific warning light on the instrument
panel (see page 112) starts flashing, and continues to flash for
90 seconds. The warning light then remains on in fixed mode until
the situation is corrected.
The TYRES screen page cannot be called up by the driver.
System not active
For a few seconds at key-on, if the TPMS has been deactivated by a
diagnostic tool, the screen page in example
Simultaneously, the specific warning light on the instrument
panel (see page 112) starts flashing, and continues to flash for
90 seconds. The warning light then remains on in fixed mode until
the situation is corrected.
The TYRES screen page cannot be called up by the driver.
TPMS inactive
18
18 is displayed.