Cleaning The Sensors - Ferrari 2012 F12 Berlinetta Owner's Manual

If the front sensors are deactivated, the display does not show the
symbols in the front. In the same way, if front sensors are fitted
and the rear ones are not activated, the display only shows the
symbols in the front. If all the sensors are activated, the system can
give several pieces of information at the same time: if an obstacle
is detected at a maximum distance in the front central part and at
a minimum distance in the rear right part, it will be displayed as
shown below.
About your Vehicle
104
If the parking sensor system symbols are being displayed and an
event occurs that needs to be displayed as an icon and/or special
message, the symbol is moved from the centre of the display to the
right as shown below.

Cleaning the sensors

When cleaning the sensors, be very careful not to scratch or
damage them and avoid using dry, rough or hard cloths.
The sensors must be washed with clean water and car shampoo
added if necessary. In car washes that use steam jet or high
pressure water cleaning equipment, quickly clean the sensors
keeping the nozzle at a distance of at least 10 cm (4 in.). For the
repainting of bumpers or retouching the paintwork in the sensor
area, contact the Ferrari Service Network. If paint is applied
incorrectly, it may prevent the parking sensors from working
properly.
Catalysts temp.
too high
Engine
performance
limited