SOYO 5ehm User Manual page 38

34
IDE Primary Master PIO/
IDE Primary Slave PIO/
IDE Secondary Master
PIO/
IDE Secondary Slave PIO
IDE Primary Master
UDMA/
IDE Primary Slave
UDMA/
IDE Secondary Master
UDMA/
IDE Secondary Slave
UDMA
Onboard FDC Controller
Onboard UART 1
Onboard UART 2
Onboard UART 2 Mode
IR Duplex Mode
Choose Auto (default) or mode 0~4.
Mode 0 is the slowest speed, and HDD
mode 4 is the fastest speed. For better
performance and stability, we suggest
you use the Auto setting to set the HDD
control timing.
Choose Auto (default) or Disabled.
Auto Ð Supports Ultra DMA mode.
Enabled Ð Use the on-board floppy
controller (default).
Disabled Ð Turn off the on-board floppy
controller.
Choose UART 1 & 2Õs I/O address. Do
no set port 1 & 2 to the same value
except for Disabled. Choose Auto for
automatic setting for the I/O address and
IRQ.
COM1/3F8H
COM2/2F8H
(default)
Choose Standard (default), HPSIR, or
ASKIR to meet the specification of your
Infra Red device.
Use the default setting (Half). This
function shows up only when either
HPSIR or ASKIR is chosen in the
previous function (Onboard UART 2
Mode).
BIOS Setup
COM3/3E8H
COM4/2E8H