White Rodgers NP110 Install Manual page 18

5.6 Operating features
Now that you are familiar with the thermostat buttons and display, read the following information to learn about the
many features of the thermostat.
• SIMULTANEOUS HEATING/COOLING SETPOINT STORAGE — You can enter both your heating and cooling
setpoints at the same time. There is no need to re-enter the thermostat at the beginning of each season.
• TEMPERATURE SETTING — Press
The thermostat will keep the room temperature at the selected temperature.
• °F/°C CONVERTIBILITY — The factory default setting is Fahrenheit. Clipping W904 jumper on the circuit board
will alter this feature to Celsius temperature setting. See diagram on page 11.
• LOW BATTERY INDICATOR — If the 2 "AAA" alkaline batteries are low and should be replaced, the display will
be blank except for
to operate for ten seconds. After ten seconds, the display will be blank except for
setpoint in COOL mode and drop the temperature 10° below your setpoint in HEAT mode. You cannot program
with low batteries, but you can override setpoint temperature.
18
. When the batteries are low, pressing any button will cause the display
has been displayed for 4 weeks, the thermostat will raise the temperature 10° above your
or until the display shows the temperature you want.
. After