3Com 4500 Quick Reference Manual page 9

Command
ip http
ip ip-prefix
ip route-static
lacp system-priority
link-aggregation group [x]
description
link-aggregation group [x]
mode
local-server
local-user
local-user password-display-
mode
loopback-detection enable
loopback-detection interval-
time
mac-address
mac-address timer
mac-authentication
mac-authentication authmode
mac-authentication
authpassword
mac-authentication
authusername
mac-authentication domain
mac-authentication timer
memory auto-establish
memory limit
memory safety
ntp-service access
ntp-service authentication
ntp-service authentication-
keyid
ntp-service max-dynamic-
sessions
ntp-service reliable
ntp-service source-interface
ntp-service unicast-peer
ntp-service unicast-server
password-control
password-control super
poe disconnect*
poe legacy enable*
poe power-management*
poe update*
private-group-id
qos cos-local-precedence-map
radius nas-ip
Description
Configure HTTP
Configure an address prefix list or one of its items
Configure a static route
Configure LACP system priority value
Configure a descriptor for an aggregation group
Create a manual or static aggregation group. X=1-32
Specify local RADIUS server configuration information
Specify local user configuration and enter local-user view (See
Table 5, "Local-user View," on page
Specify password display mode
Enable port loopback detection
Configure the detection interval for the external loopback
condition of each port
Configure MAC address
Configure the aging time of the Layer-2 dynamic address
table entry
Enable the centralized MAC address authentication feature on
a specified port or globally
Specify MAC authenticate authmode config
Specify the fixed password
Specify the fixed username
Configure the ISP domain used by the centralized MAC
address authentication user
Configure timer parameters of the centralized MAC address
authentication
Free memory for routing protocols to run normally
Specify the memory limit
Display memory safety
NTP access control
Authenticate NTP timie source
Specify NTP authentication keyid
Specify the maximum connections
Specify trusted keyid of NTP
The interface correcponding to the sending NTP packet
Specify the NTP peer
Specify the NTP server
Specify password controls
Super user's password controls
Set PoE disconnect mode
Enable Legacy detection
Power Management
Update PoE firmware
Tunnel Private Group ID attribute description mode
Configure "CoS Local-precedence" mapping table
Specify the source address of the RADIUS packet sent from
NAS
9
Web Command
Security -> Authorized IP
Device -> IP Route
Port -> LACP
Port -> Link Aggregation
Port -> Link Aggregation
Administration ->
11) System Access