3Com 4500 Quick Reference Manual page 17

Command
if-match acl
if-match IP
if-match IP-prefix
if-match tag
if-match cost
if-match interface
if-match ip next-hop
Table 17 RIP View
[4500]rip
Command
checkzero
default cost
host-route
filter-policy
import-route
network
peer
preference
reset
summary
timers
Table 18 ACL View
[4500]acl number xxxx
(where xxxx is the acl number)
Command
description
rule
Copyright © 2007, 3Com Corporation. All rights reserved.
www.3Com.com
Part Number: 10015872 Rev. AA
Published: January, 2007
Description
Configure the IP address range to match the acl
Configure the IP address range to match the IP
Configure the IP address range to match the IP prefix
Configure the IP address range to match the tag
Configure one of the match rules of route-policy to match
the cost of the routing information
Set to match route whose next hop is designated interface
Configure one of the match rules of route-policy on the next
hop address of the routing information
Description
Perform the checkzero operation in the zero field of RIP-1
default routing cost of an imported route
Enable receiving host-routes
Spcify a route filtering policy
Import routes from other protocols into RIP
Enable routing protocol on the related network or interface
Specify a peer route
Specify an RIP route preference
Reset RIP configuration
Enable RIP-2 automatic route summarization
Config RIP timers
Description
Specify the ACL description
Add a subrule to an ACL
17
Web Command
Web Command
Web Command
Device -> ACL
Security -> Authorized IP