Wireless
-
2.4GHz It works in 2.4GHz frequency spectrum
High output power Transmit high output power programmable for different country selections
-
High Data Rate High speed transmitting rate up to 54Mbps, support large payload such as MEPG video
-
streaming
-
Multifunction application Access Point/Client Bridge/Client Router/WDS Function
Long range transmitting Transmit power control and distance control (ACK timeout)
-
Narrow Bandwidth Provide 5MHz/10MHz/20MHz bandwidth selection
-
-
Signal Strength Display RF signal strength status shown LEDs of 3 colors, making network build‐up easier.
LED indicators have the best transmit and receive signal for traffic communication
Multiple SSID 4 SSID supported. Each SSID can set itself wireless or WAN access setting.
-
-
QoS(WMM) Enhance performance and density
Networking
-
PPPoE Point‐to‐Point Protocol over Ethernet at Client Router mode. This function will keep trying when
failed or disconnected
PPTP Point‐to‐Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
-
VPN Pass Through
-
Security
802.11i WEP, WPA, WPA2 (Encryption support TKIP/AES)
-
MAC address functions MAC address filter (AP mode)
-
-
802.1x IEEE802.1x Authenticator
Station isolation
-
Management
Firmware Upgrade Upgrading firmware via web browser, setting are reserved after upgrade
-
Reset & Backup Reset to factory default. User can export all setting into a file via WEB
-
-
Ping & Trace Route Built‐in PING function & Trace Route function in Web GUI
-
MIB MIB I, MIB II(RFC1213)
SNMP V1, V2c
-
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
* Theoretical wireless signal rate based on IEEE standard of 802.11b, g chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice.
EOC1650
Access Point/ Client Bridge/WDS AP / WDS Bridge / Client
2.4 GHz
54Mbps
Features
802.11b/g
Superior Performance
5/12/2009