Table of Contents
Advertisement
Multi-Function Gigabit Wireless-N Client Bridge
2 Understanding the Hardware
2.1 Hardware Installation
1. Place the unit in an appropriate location after conducting a site survey.
2. Plug one end of the Ethernet cable into the LAN port of the device and another end
into your PC/Notebook.
3. Plug one end of another Ethernet cable to WAN port of the device and the other end
into you cable/DSL modem (Internet)
4. Insert the DC-inlet of the power adapter into the port labeled "DC-IN" and the other
end into the power socket on the wall.
This diagram depicts the hardware configuration
PC, Cable/DSL
Modem
2.2 IP Address Configuration
This device can be configured as a Bridge/Router or Access Point. The default IP
address of the device is 192.168.1.2 (In Client Bridge Mode as default)In order to log into
this device, you must first configure the TCP/IP settings of your PC/Notebook.
1. In the control panel, double click Network Connections and then double click on the
connection of your Network Interface Card (NIC). You will then see the following
screen.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
alone, the AP can extend the range of independent wireless LANs by
acting as a repeater, which effectively doubles the distance between
wireless stations. The image below depicts a network in infrastructure
mode.
Ethernet
Client Bridge/AP
AC/DC cable
Power Outlet
Version 2.0
9
Advertisement
Table of Contents
