Location; A Word About Cables - PROCEED PDP 3 User Manual

Location

PRECAUTION

A word about cables

8
You may choose instead to install the spikes in a triangular
arrangement:
Install the spikes one at a time. Using the supplied hex key, remove
the screw securing the foot to the base of the unit. Insert the
threaded end of the spike through the hole in the foot, then turn it
clockwise until it's hand-tight. (Be careful not to over-tighten it.)
Repeat this procedure for each spike you install.
4. Turn the PDP 3 upright, and place it in the desired location.
The PDP 3 should be located on a level, stable surface. Avoid
placing it where it will be exposed to shocks or vibration (such as
on an unstable table or near large loudspeakers). For best
performance, locate the PDP 3 away from tuners, televisions, and
other sources of radio frequencies.
DON'T place the PDP 3 on top of another component, since its
base could block the other component's ventilation. Interfering
with the PDP 3's ventilation or that of another component could
cause either to overheat, resulting in damage to your system.
5. Make sure that power is turned off to both the PDP 3 and your
receiver, integrated amplifier, or preamplifier/power amplifier.
The quality of the cables and connectors that you use with your
Proceed PDP 3 can noticeably affect the quality of the sound
that you hear from your speakers or headphones. For the best
performance, use the highest quality audio cables available.
Though there are many such cables to choose from, we
confidently recommend Madrigal HPC cables (for analog
signals) and Madrigal MDC (for electrical digital signals). See
your Proceed dealer for more information.
Three spikes,
mounted in a
triangular pattern