Automatic Headlamp System (Ahs); Dome Lamp Override; Dual-Zone Automatic Climate Control System - Buick Rainier 2004 Getting To Know Manual

Getting to Know Your Rainier
8
Activate the fog lamps
• Press the fog lamp button (
located on the instrument panel to the
right of the exterior lamps switch
once.
• An indicator lamp will illuminate.
• To turn them off, press the button
again.
Note: The fog lamps shut off automati-
cally when the ignition is turned off and
must be reactivated when needed.
See Section 3 of your Owner Manual.
Automatic Headlamp System
(AHS)
When encountering darker conditions
during the daytime (such as when driv-
ing under a bridge or inside a parking
garage), you may notice the AHS tem-
porarily activating your headlamps, inte-
rior lights and radio display lights. This
is normal. The lights will automatically
shut off when returning to daylight driv-
ing conditions.
When you start the vehicle at night,
the automatic headlamps will come on
immediately. The Automatic Headlamp
System light sensor is located on top of
the instrument panel near the windshield
defroster outlets. To ensure proper sys-
tem operation, avoid placing objects or
stickers on or near the sensor.
See Section 3 of your Owner Manual.

Dome Lamp Override

)
The dome lamp
override button is
located below the
exterior lamps knob.
To prevent the
dome lamp from
illuminating when a
door is opened,
press the button.
Although using your
remote keyless entry transmitter to
unlock the doors will activate the dome
lamp temporarily, the lamp will remain
deactivated when opening a door, until
the override button is pressed again.
See Section 3 of your Owner Manual.
Dual-Zone Automatic Climate
Control System
Your vehicle is equipped with a climate
control system that automatically main-
tains the desired temperature individual-
ly for the driver and front seat passen-
ger. Independent rear seat fan and air
distribution controls are also included for
increased rear-passenger comfort. A
memory feature for up to two drivers is
also included with this system.
Automatic Operation: Push the AUTO
button to set automatic air delivery
mode, fan speed, A/C and recirculation
functions. Each time the AUTO button is