Battery Led Indicator; How To Control Your Model - Hobbytech NXT SPIRIT Instruction Manual

bINd
A
Place model on a block to prevent wheels from touching the
ground.
A
Connect battery to ESC. Fix the wire correctly with the
provided connectors.
You must check the signal of transmitter and receiver before
you operating it at first.
Make sure Th Trim is on neutral
- TuRN OFF ThE TRANSMITTER AND RECEIVER -
B
Press and Hold the BIND button on the receiver while
C
turning on the receiver .
Release the BIND button when the LED flashes green.
While the green LED flashes, press the BIND button to select
the frame rate.
- Faster flashes= high frame rate (7ms), for digital servo
- Slower flashes= low frame rate (15ms), for analog servo
D
Press and Hold the BIND key of the Transmitter (1),
and then turn on the Transmitter (2), the Transmitter will
communicate with the receiver.
When the receiver LED is solid on, the pairing process is done,
and the receiver is paired with the transmitter.

bATTeRy Led INdICATOR

- During normal operation, the LED should be solid green ON
- When battery voltage is dropped below 3.8V, the LED will become red color and flashing very slowly, to indicate battery is
low, you should replace new battery as soon as possible.

hOw TO CONTROL yOUR MOdeL (1)

fORwARd / Speed
Up pOSITION
1. Pull up the trigger in order to brake or speed down
B
C
D
bRAke / Speed
dOwN pOSITION
NeUTRAL pOSITION
2. Pull the trigger in order to go forward or speed up
(2)
(1)
7