Advertisement
Quick Links
Section 1
General Information
It is
recommended that this ice machine be inspected and
installed by a qualified service technician.
If you do not understand the procedures or the safety
precautions that must be followed, call your local service
representative to perform the necessary installation
procedures for you.
Model Numbers
This manual covers the following models:
Model Numbers Identification
EC S 040 A
Ice Machine Model
WARNING
Self-Contained
Air-Cooled
ECS018A
ECG018A
ECS020A
ECG020A
ECS030A
ECG030A
ECS040A
ECG040A
ECS050A
ECG050A
ECS065A
ECG065A
ECS080A
ECG080A
Ice Cube Size
S – Standard Cube
G – Large Cube
Installation Instructions
Follow all recommendations and instructions for proper
installation and safe operation of this ice machine.
PERSONAL INJURY POTENTIAL
Do not operate equipment that has been misused, abused,
neglected, damaged, or altered/modified from that of original
manufactured specifications.
Self-Contained
Water-Cooled
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
ECS040W
ECG040W
ECS050W
ECG050W
ECS065W
ECG065W
ECS080W
ECG080W
Ice Machine Series
WARNING
Condenser Type
A – Air Cooled
W – Water Cooled
1-1
Advertisement
Related Manuals for Manitowoc ECS018A
Summary of Contents for Manitowoc ECS018A
-
Page 1: Installation Instructions
Model Numbers This manual covers the following models: Self-Contained Self-Contained Air-Cooled Water-Cooled Not Available ECS018A Not Available ECG018A Not Available ECS020A ECG020A Not Available ECS030A Not Available ECG030A Not Available... -
Page 2: Location Of Ice Machine
Section 1 Installation Instructions Location of Ice Machine Leveling the Ice Machine The location selected for the ice machine must meet the Levelers are included with all ice machine. Legs are an available following criteria. If any of these criteria are not met, select option. -
Page 3: Electrical Service
Section 1 Installation Instructions Electrical Service GENERAL WARNING WARNING All wiring must conform to local, state and national codes. The ice machine must be grounded in accordance with national and local electrical codes. VOLTAGE The maximum allowable voltage variation is ± 6% of the rated FUSE/CIRCUIT BREAKER voltage on the ice machine model/serial number plate at start-up A separate fuse/circuit breaker must be provided for each ice... -
Page 4: Water Service/Drains
The floor drain must be large enough to accommodate pressure, obtain a water pressure regulator from your drainage from all drains. Manitowoc distributor. Adjust pressure to 2.5 bar (37 psi). • • Run separate bin and water-cooled condenser drain lines. - Page 5 Section 1 Installation Instructions Dimensions ELECTRICAL POTABLE WATER WATER COOLED INLET CONDENSER OUTLET WATER COOLED DRAIN CONDENSER INLET 152.4 mm (6 in) Condenser Water Condenser Water Potable Water Inlet Drain Electrical Inlet Outlet MODEL 63.5 88.9 50.8 76.2 38.1 EC018 INCH 25.0 13.5...
-
Page 6: Installation Checklist
Are all electrical leads free from contact with refrigeration lines and moving equipment? Has the owner/operator been instructed regarding maintenance and the use of Manitowoc Cleaner and Sanitizer? Has the owner/operator completed the warranty registration card? Has the ice machine and bin been sanitized?