Technical Assistance Service; Troubleshooting - Bosch NIT3065UC Use And Care Manual

Technical Assistance Service

Troubleshooting

The cooktop is not working
The indicator light on the
element is flashing E
The cooktop turns off by itself
The display flashes (there is no
power) when you place a saucepan
on an induction cooking element
The SpeedBoost function display
flashes and then switches off
Repairs
Display E Ö and numbers
Display F and numbers
26
Sometimes problems are unimportant technical problems that can be easily
resolved. Before contacting Technical Assistance, please keep in mind the advice
and warnings below:
See if there is a power outage. Check to see if there is a problem with the circuit
breaker for the electrical installation.
The control panel is very dirty, food has spilled or there is something on top of the
cooktop. Clean the control panel or remove the object from the cooktop. Lightly
press the affected control panel. The flashing should stop.
The power key was touched unintentionally. Press the power key again. Reset the
cooktop.
Check to see whether the saucepan is electromagnetic. Check to see whether the
diameter of the saucepan is large enough. Allow the saucepan to cool down in the
event that it has become too hot when used.
If the display still does not light up when you switch the cooking element off and on
again, disconnect the appliance at the circuit breaker. Wait 20 seconds and then
reconnect it.
The SpeedBoost function operates the cooking element with the most possible
power. During long cooking times, it is possible that the function will switch the
cooking element off to protect the cooktop from overheating. You can continue to
use the cooktop if the display is not flashing.
WARNING: Repairs should only be done by a trained service technician.
d
If your appliance is repaired improperly, you could be at considerable risk.
If an E Ö and a series of numbers appear in the display panel, there is a fault in the
electronic system. Turn the appliance off and back on at the fuse or circuit breaker.
Call technical assistance if the same display appears again.
If an F and a number flash in alternation on the displays, your appliance has
detected a fault. Refer to the following table for possible remedies.