Advertisement
Available languages
Available languages
ENGLISH
1
Socket
2
Anvil
3
Counterclockwise
SPECIFICATIONS
Model
Capacities
Bolt size .................................................................................... 12 mm – 20 mm
Square drive .............................................................................12.7 mm
Impacts per minute ...................................................................... 2,000
–1
No load speed (min
) ................................................................. 1,700
Tightening torque ........................................................................3,000 kg•cm
Overall length .............................................................................. 270 mm
Net weight ................................................................................... 2.7 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.
ADDITIONAL SAFETY RULES
FOR TOOL
1.
Wear ear protectors.
2.
Check the socket carefully for wear, cracks or
damage before installation.
3.
Hold the tool firmly.
4.
Always be sure you have a firm footing. Be sure
no one is below when using the tool in high loca-
tions.
5.
The proper tightening torque may differ depend-
ing upon the kind or size of the bolt. Check the
torque with a torque wrench.
SAVE THESE INSTRUCTIONS.
4
Explanation of general view
4
Reversible switch
5
Clockwise
6
Limit mark
OPERATING INSTRUCTIONS
Holding the tool
Hold the tool firmly with one hand on the gripping part of
the tool and the other hand on the side grip when per-
forming the tool.
Selecting correct socket
Use a correct size socket for bolts and nuts. A wrong size
socket will result in inaccurate and inconsistent tightening
torque.
Installing the side grip (Fig. 1)
For 6906 only
Fit the side grip into the groove on the middle of the ham-
mer case and fasten securely.
Attaching the socket (Fig. 2)
Selecting a proper socket in size, please insert it into the
anvil so as to fix securely.
Switch action (Fig. 3)
CAUTION:
• Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to the
"OFF" position when released.
• Change the direction of rotation only after the tool
comes to a complete stop. Changing it before the tool
stops may damage the tool.
The switch is reversible, providing either clockwise or
counterclockwise rotation. To start the tool, simply pull
the lower part of the switch for clockwise, the upper part
for counterclockwise. Release the switch to stop.
7
Screwdriver
8
Brush holder cap
6905B
6906
16 mm – 22 mm
19 mm
1,600
1,700
6,000 kg•cm
327 mm
5.0 kg
Advertisement
