Download Print this page

Troubleshooting - Zanussi ZDF14011WA User Manual

Hide thumbs Also See for ZDF14011WA:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 51
Internal cleaning
If you regularly use short duration pro-
grammes, these can leave deposits of grease
and limescale inside the appliance.

Troubleshooting

The appliance does not start or it stops during
operation.
Before you contact the Service, refer to the in-
formation that follows for a solution to the
problem.
With some problems, the display shows
an alarm code:
- The appliance does not fill with water.
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If the display shows other alarm codes, con-
tact the Service.
60
To prevent this, we recommend to run long
duration programmes at least 2 times per
month.
- The appliance does not drain the wa-
ter.
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the end
of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a low-
er position.
• The quantity of detergent is too much.
www.zanussi.com

Hide quick links:

Advertisement

Chapters

loading

This manual is also suitable for:

Zdf14011xa