Capresso Cafe PRO 125.05 Instructions And Warranty page 13

NOTE: If no steam comes out of the frothing wand, hardened milk may be
built up inside of the frothing wand. See chapter 12, Troubleshooting on how
to clean the blocked frothing wand.
c) Fill a small pitcher or cup with cold water and immerse the frothing wand
deep into the cold water so it is close to the bottom of the pitcher.
d) Turn the Selector Dial to the right, steam/frothing "
e) Hold the frothing wand at the bottom of the pitcher for 20 to 30 seconds
then turn the Selector Dial back to the center "•" position
f) Remove pitcher from frothing wand and wipe frothing wand with a damp cloth.
g) Turn the machine OFF by pressing the ON/OFF button until the blue indicator
light turns off.
10. Cleaning and Maintenance
a) Always disconnect the plug from the wall outlet and allow the appliance to
cool down completely before cleaning.
b) Do not immerse the appliance in water or any other liquid.
c) Do not use harsh abrasives to clean. Wipe down the appliance housing with
a damp cloth.
NOTE: Do not clean with alcohol or solvent cleanser.
d) Wipe the brew head with a damp cloth.
CAUTION! HOT! Danger of burning or scalding! Allow the appliance to cool
down completely before cleaning.
e) Rinse the water tank, the grid and drip tray regularly with water.
f) Empty the drip tray regularly and clean with hot soapy water.
g) Detach the sieve from the portafilter by turning it until the bump on the sieve
lines up with the notch in the portafilter (Fig. 2), remove coffee residue with a
stiff bristled brush. If any coffee particles are stuck in the small holes, they
can be removed with a pin.
h) If the inner screen inside the brew head, (Fig. 4) accumulates coffee oils, it
can be unscrewed for a thorough cleaning using a screwdriver. Ensure it is
attached back onto the machine the same way after cleaning.
i) Clean the seal around the brew head with a damp cloth and always keep it
clean to maintain the life of your machine.
j) Clean the frothing wand after every use. See chapter 9.
k) Remove the tip of the frothing wand and soak in hot water. Clean the threads of
the frothing tip with a hot damp cloth. Regularly inspect the opening of the
frothing wand to ensure there is no milk build up. Regularly inspect the o-ring
of the frothing tip to guarantee its integrity. If there is any damage (rips or
tears) to the o-ring call Customer Service to order a replacement. Screw the
frothing tip (with o-ring) back onto the frothing wand. (see Fig. 5).
" position to release steam.
13.