Park Brake; Caster Wheels - Husqvarna PZ 60 Operator's Manual

MAINTENANCE
Deck Lift Spring
When mowing 2" or lower, it may be necessary to
adjust the deck lift springs. Access the springs by
tilting the seat forward.
Loosen the nut to adjust the spring tension.

Park Brake

Visually check that no damage is found on the
lever, links, or switch belonging to the park brake.
Perform a standstill test and check that there is
sufficient braking.
WARNING! Faulty adjustment will result
in reduced braking and can cause an accident.
Park Brake Adjustments
1. Using a jack stand, raise the rear of the
mower up off the ground. Make sure the
machine is securely supported.
2. Remove the rear tire assemblies.
3. Release the park brake.
4. Measure the distance from the swivel to the
washer. The measurement must be 1-3/4"
on both the right and left side brake linkage
assemblies.
1-3/4"
5. If adjustments are needed, loosen B jam nut
and turn A jam nut until the correct distance
is achieved. Retighten B jam nuts against A
jam nuts.
28
D
6. Engage the park brake. Measure the distance
between the D brake bolt and the brake
swivel. The distance must be 1/8"-1/4".
7. If adjustments are needed, loosen C jam
nut. Turn the brake bolt until the distance is
correct. Retighten C jam nuts.
1/8"-1/4" gap
with park brake
engaged

Caster Wheels

Check every 200 hours. Check that wheels rotate
freely.
To replace, remove nut and caster bolt. Pull the
wheel out of the fork. Install in reverse order.
Tighten caster bolt. Torque to 45 ft-lbs (61 Nm),
then back nut off 1/2 turn.
NOTE: Tire must rotate freely but axle spacers
must not. If wheels do not rotate freely take the
unit to the dealer for service.
B
A
C