Voip Settings - Intelbras TIP 200 Installation Manual

3. Use the alphanumeric keypad to enter the password (factory default: admin)
and press
4. Use the
5. Use the
6. Use the
7. Use the alphanumeric keypad to enter the number of the IP address and press
;
8. If the address entered is not valid, the following warning will appear on the
display: "Warning Invalid Value";
9. If the address does not belong to the mask of the sub-network and the default
gateway, these must also be configured.
Note: press
settings will be applied.
PPPoE
1. Press Menu, use the
2. Use the
3. Use the alphanumeric keypad to enter the password (factory default: admin)
and press
4. Use the
5. Use the
6. Use the
7. Use the alphanumeric keypad to enter the PPPoE user;
8. Use the
and press
Note: press
settings will be applied.
After confirmation, it will be possible to access the Internet. Continue with the
following configuration.

4.4. VoIP settings

After configuring the network, it is necessary to have information from your VoIP
operator in order to be able to make your calls. This device supports up to two
different operator accounts. The information from each operator is to be included
42
;
keys to select Network and press
keys to select WAN Port and press
keys to select Static IP and press
, or wait 1 minute and the
key to select Settings and press
keys to select Advanced and press
;
keys to select Network and press
keys to select WAN Port and press
keys to select PPPoE and press
keys to select PPPoE PWD, enter the password of the PPPoE user,
.
or wait 1 minute and the device will reinitialize and the new
;
;
;
device will reinitialize and the new
;
;
;
;
;