Table of Contents
Advertisement
4.
Type the Primary Domain Name Server address your ISP gave you. Press Return. A new field Secondary
Domain Name Server will appear. If your ISP gave you a secondary domain name server address, enter it
here. Press Return until the next field Default IP Gateway is highlighted.
5.
If you do not enter a Default IP Gateway value, the router defaults to the remote IP address you entered in
the Easy Setup connection profile. If the Netopia Router does not recognize the destination of any IP traffic,
it forwards that traffic to this gateway.
Do not confuse the remote IP address and the Default IP Gateway's address with the block of local IP
addresses you may receive from your ISP. You use the local IP addresses for the Netopia 4-port ADSL
Router's Ethernet port and for IP clients on your local network. The remote IP address and the default
gateway's IP address should point to your ISP's router.
6.
Toggle IP Address Serving to On or Off, depending on whether you want the device's IP address server to
supply dynamic IP addresses to your client workstations. Normally, you would accept the default On so that
workstations on your LAN can have IP addresses assigned dynamically from the router.
7.
The Netopia Router's built-in IP address server will provide 100 IP addresses automatically to workstations
on your LAN. You only need to change the Number of Client IP Addresses if you have some other IP
addressing scheme.
8.
By default, the 1st Client Address is 192.168.1.100, based on the device's default IP address of
192.168.1.1. You only need to change this if you have some other IP addressing scheme.
9.
Press the Down arrow key until you reach NEXT SCREEN. Press Return.
Easy Setup 6-7
Advertisement
Table of Contents
