Table of Contents
Advertisement
6-4 Getting Started Guide
1. ADSL Line Configuration
Trellis Coding Enabled:
Fast Retrain Enabled:
Wiring Type...
Data Link Encapsulation...
Data Circuit VPI (0-255):
Data Circuit VCI (32-65535):
PREVIOUS SCREEN
Return/Enter brings you to next screen.
1.
Select Trellis Coding Enabled. Toggle it to On (the default) or Off. Unless otherwise specified by your
provider, you can accept this default.
2.
Select Fast Retrain Enabled. Toggle it to On (the default) or Off. Unless otherwise specified by your
provider, you can accept this default.
3.
Select Data Link Encapsulation and from the pop-up menu choose either RFC1483 (the default) or PPP.
4.
The next two fields, Data Circuit VPI and Data Circuit VCI are editable. Enter the Virtual Path Identifier and
Virtual Channel Identifier values that your provider specifies. VPI 8/VCI 35 are the most common. Your
provider must specify these values.
5.
Press the Down arrow key until you reach NEXT SCREEN. Press Return to bring up the next screen.
ADSL Line Configuration
On
On
AutoSense
RFC1483
8
35
NEXT SCREEN
Advertisement
Table of Contents
