Advertisement
After you have
run
the
initial
setup, you can configure or
reconfigure
the network connections through the
TV's
menu.
Configuring
a
Wireless Network Connection
The instructions below
are
for networks
that
use
the Dynamic Host Configuration Protocol
(DHCP)
to
configure network connections automatically. Most wireless networks use DHCP
lf
you
have a
Static
lP
network,
see
the e-Manual for configuration instructions.
To
configure the network connection for a network
that
uses
DHCP,
follow these steps:
1
.
Connect your
W
to your network
as
shown
in
the
illustration
on page
'15.
2.
Turn on
your
TV
and then go
to
the
Network Settings
screen. (Menu
*
Network
+
Network
Settings)
3.
Select
Start.
The Network function searches for
available
wireless networks. When done,
it
displays
a
list
of the
available
networks.
4.
ln
the
list
of networks, move the highlight
to
select a network, and then select Next.
\
lf
you
have a WPS(PBC)
compatible
router,
select WPS(PBC) instead, and then follow the
directions on the screen.
5.
Enter
your network security key
or
WPS
PIN
using your
remote.
\
Enter numbers
and
letters using your
remote.
.
Enter
numbers by
pressing
the number buttons
on
your
remote.
.
To
enter a
letter, move
the
Highlight to the
letter,
and then select
it. You
can enter numbers
in
the same fashion
if
you choose.
5
To
display capital letters
(or
redisplay small letters
if
capital letters
are
displayed), select
Caps
or
shift.
\
To
display symbols and punctuation,
select
1*.
To
redisplay letters,
select
1*
again.
6.
When done, select
Next
if
you
have
entered
a
security
key
or
WPS
PIN
if
you
have
entered
a
WPS
PlN.
7.
The
W
checks the wireless connection,
lf
the connection
is
successful,
the
"You are
connected to the
lnternet.
lf
you have any problems using online services, please
contact
your lnternet Service
Provider."
message appears. Select
Next
using
your
remote.
S
For
more detailed information, see "Setting up the Wireless
Network"
in
the e-Manual.
5,
lf
you want
to
configure the
connection
manually, select lP
Settings
on
the
Network Connection
screen. Set
lP Mode to Enter manually,
and then enter
the
lP
Address, Subnet Mask,
Gateway, and
DNS
Server
manually.
Advertisement
