Cisco ubr924 Installation And Startup page 26

Reconfigure the Router (continued)
VoIP (Using H.323v2) Routing Example
Note: You can also configure the Cisco uBR924 cable access router to act as a router when supporting VoIP
traffic. IP addresses for the session targets must be valid for your network and must be for a router configured
to support voice. If not configured to support voice, calls will not be completed.
24
Current configuration:
!
Last configuration change at 23:24:55 - Thu Mar 18 1999
!
version 12.0
service config
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Router
!
clock timezone - 4
ip subnet-zero
ip host-routing
!
voice-port 0
!
voice-port 1
!
dial-peer voice 1 pots
destination-pattern 1001
port 1
!
dial-peer voice 2 pots
destination-pattern 1000
port 0
!
dial-peer voice 10 voip
destination-pattern 1001
codec g711ulaw
session target ras
!
dial-peer voice 20 voip
destination-pattern 1000
codec g711ulaw
session target ras
!
dial-peer voice 30 voip
destination-pattern 2000
codec g711ulaw
session target ras
!