Attach The Antennas And Connect The Access Point To Your Computer - NETGEAR prosafe wn203 Installation Manual

Attach the Antennas and Connect the Access Point to
Your Computer
1. Attach the antennas to the SMA antenna connectors on the back panel.
2. Prepare a computer
with an Ethernet
adapter:
a. If this computer is
already part of your
network, record its
TCP/IP
configuration
settings.
b. Configure the
computer with a
static IP address of
192.168.0.210 and
a subnet mask of
255.255.255.0.
3. Insert an Ethernet
cable in the Ethernet
port of the computer
(point A in the
illustration).
4. Securely insert the other end of the cable into the Ethernet LAN port on the
back panel of the access point (point
5. Connect the power adapter to the access point and plug the power adapter
into a power outlet.
6. Verify the following:
Power LED. The Power LED is green. If the Power LED is off, check
the connections, and check if the power outlet is controlled by a wall
switch that is turned off.
Test LED. The Test LED blinks amber at startup and turns off after
about one minute.
LAN LED. The LAN LED indicates LAN speeds: green for 1000 Mbps,
amber for 100 Mbps or 10 Mbps. If no link is detected, the LAN LED is off.
WLAN LED. The WLAN LED is blue, indicating that the wireless LAN
(WLAN) is ready.
English
Console port
Antenna connector
B in the illustration).
2
A
LAN port Power
connector
Antenna connector
B