Package Contents; Set Up The Access Point - NETGEAR prosafe wn203 Installation Manual

Installation Guide
ProSAFE® Single Band 802.11n Wireless Access Point WN203
Follow the instructions in this installation guide to set up your ProSAFE® Single
Band 802.11n Wireless Access Point WN203. For information about advanced
configuration options, see the reference manual.
Note: In this installation guide, the Wireless Access Point WN203 is referred to as
the access point.

Package Contents

Unpack the box and verify the contents:
• Wireless Access Point WN203
• Two external 2.4 GHz antennas
• Straight-through Category 5 Ethernet cable
• Power adapter and cord (12V, 1A)
• Stand
• Two wall mount screws and anchors
• Resource CD
• Installation guide

Set Up the Access Point

Setting up the access point consists of three short procedures:
• Attach the antennas and connect the access point to your computer.
• Configure the LAN and wireless access settings.
• Test wireless connectivity.
Estimated total time for these procedures: 15 minutes.
Tip: Before you mount the access point in a high location, first set up
and test the access point to verify wireless network connectivity.
English
1