Installing On Aircraft - Safety 1st alpha omega elite Instruction Manual

4358-4837 Elite SF1 EOU 7/10/09
4.
5.
6.
7.
35
2:47 PM Page 37
Tighten Vehicle Belt
Push down firmly on the
child restraint and while
pulling on the shoulder belt
to tighten.
Locate Locking Clip
Location
Grasp both vehicle belts
together just behind the
latch plate and unbuckle.
NOTE: If the latch plate
ends up just at the belt path
opening, grasp the belts on
the opposite side of the
child restraint, as close to
the latch plate as possible.
Attach Locking Clip
Thread both portions of the
vehicle belt onto the locking
clip, as close to the latch
plate as possible.
Position Locking Clip
Position locking clip about
1 in. (2.5 cm) from vehicle
belt's latch plate.
8. Rebuckle Vehicle Belt
9. Check Belt Tightness
Grasp the child restraint at
the belt path with one
hand. Push and pull the
child restraint from side to
side, forward and back.
The child restraint should
not move more than 1
inch.
NOTE: If it moves more than an inch, redo the steps 5 through
9 again or try another seating location.
Remove the locking clip when the seat belt is not being
used with a child restraint.
D-6 Installing on Aircraft
This restraint is certified
for aircraft use only when
used with the internal
harness. This child
restraint is NOT certified
for use in aircraft when
used as a belt-
positioning booster, because aircraft seats do not have
shoulder belts.
Use only on forward-facing aircraft seats. Follow instructions
for vehicle installation.
Contact the airline their specific policies.
36