Table of Contents
Advertisement
MX8000-3EX Installation and Operation Guide
4.3
Initial System Power Up
Apply power to the MX8000–3EX by plugging in the AC power cable. (See Figure 3–3.) When the MX8000–
3EX powers up, the display will go through the routine shown in Figure 4–4.
Receiver cycles
between these
displays until
initialization
is complete
The system defaults in the manual operation. To select automatic operation see Section 5.3.1.1.
Note: Any time the power is removed from the receiver (line and battery), the time and date will have to be
reprogrammed on power-up.
4.4
Log On / Log Off
Persons operating the MX8000–3EX must log on and off the system. This is a way of keeping track of who is
operating the system at any given time. You can program a total of 40 codes. Each code will be assigned to
one of two user profiles (Installer profile or Operator profile). (See Section 4.4.3 for default user codes.)
4.4.1
Installer Profile
The Installer profile will have access to all options on the main menu (see Table 4–4 for "Main Menu"
options).
4.4.2
Operator Profile
The Operator profile has access to fewer main menu options than the Installer profile (see Table 4–4). These
options allow the operator to perform basic operation of the MX8000–3EX. Both profiles can acknowledge all
calls and events.
4–4
User Number
Us#
Area Number
A#
123123C 11/13/00
Internal Keypad
MX8000 Receiver
Ademco
Man: Active
<Initializing...>
MX8000 Receiver
Ademco
Man: Active
04/02/02
09:43:46AM
Figure 4–4: Power-up Routine
Table 4–4: Main Menu Option Items by Profile
Installer
Operator
Profile
✔
✔
User
Area
Powerup Screen
Self Test
Normal Operation
Line Card Initialization(No Events)
Lines 1&2 Model and Manufacturer banner
Line 3 System Status
Line 4 Date and Time
Menu Options
Profile
✔
Call History
✔
System History
Advertisement
Table of Contents
Troubleshooting
