Replacing The Battery; Cleaning And Maintenance; Service Centre - no-flame 83198 Instruction Manual

Use
Choose a suitable place to install the smoke
alarm.
As smoke rises, we recommend installing
the smoke alarm on the ceiling in the
middle of a room.
Twist the casing (1) off the mounting plate
(6). Screw the mounting plate securely to
the ceiling.
Insert a 9 V battery into the battery
compartment of the smoke detector (4)
and three 1.5 V batteries into the battery
compartment of the transmitter (5).
Twist the casing securely onto the mounting
plate. Press and hold the test button (2).
The alarm should go off after a few seconds.
Release the button.
When the alarm is functioning correctly, the
red LED will flash every 43 seconds.
Connecting several smoke alarms
in a network
1. Select one alarm to serve as the main
alarm. Put it aside.
2. Select an alarm to be connected to the
main alarm.
3. Press the LEARN button (3) on this alarm
several times, so that the LED shines
red.
4. If you are connecting several alarms, you
should repeat point 3 for all the alarms
to be connected to the main alarm.
5. Press the test button on the main alarm
and hold it in until all alarms sound.

Replacing the battery

When the batteries are about to run out, the
smoke alarm emits a loud warning signal.
If the 9 V battery in the smoke detector is
about to run out, the warning signal sounds
every 43 seconds.
If the three 1.5 V batteries in the transmitter
are about to run out, the warning signal
sounds every 60 seconds.
Replace the battery as soon as possible,
and test the smoke alarm by pressing and
holding the test button.
Remember to reconnect the smoke alarm to
the network.

Cleaning and maintenance

Wipe the smoke alarm down regularly with
a well-wrung cloth. Vacuum the casing if it
becomes dusty.

Service centre

For:
• Complaints
• Replacements parts
• Returns
• Guarantee issues
• Open 7.00 to 16.00
• E-mail: service@hpv.dk
DK
NO
SE
FI
GB
DE
PL
ET
19