3 Installation
This chapter provides specific information enabling you to install
the TT-3005M Capsat Antenna into your own system, with a
minimal effort.
3.1
Transceiver Configuration
This new antenna is designed to use a very low amount of power.
To ensure that the transceiver detects the antenna as connected
the voltage output of the transceiver has to be reduced. Issuing
the following command in the transceiver shell does this:
"Se –f 0"
If this command is not run the transceiver will probably set-up a
warning box stating that the antenna is not connected.
3.2
Mounting
The TT-3005M maritime antenna is constructed for 1" tube
mounting.
16Aug06
Installation
Page 3-1