Installation Procedure For Windows Xp - Belkin F5U222 User Manual

Installation Procedure for Windows XP

Important Note: If you have already upgraded to Windows XP Service Pack 1,
support for your Notebook Card is already installed on your computer. If you
have not upgraded to Windows XP Service Pack 1, or if you wish to use the
Belkin driver, proceed to the "Installing Belkin Driver" section.
Using the Windows XP Service Pack 1 Driver
This installation procedure will install two USB 1.1 OHCI controllers and one
USB 2.0 EHCI host controller.
1. Locate your computer's CardBus slot.
2. Insert the Notebook Card into the slot. Apply pressure as needed until the
Card is fully seated.
3. Turn on your computer.
4. When Windows restarts, the Notebook Card will be detected and drivers
for the two USB OHCI host controllers and the EHCI host controller will be
automatically installed. Installation is now complete.
Verifying Proper Installation (Microsoft Driver)
After installation, check the Device Manager to confirm that the Notebook
Card has been properly installed.
1. Right-click on "My Computer".
2. Select "Properties".
3. Select the "Hardware" tab and click on the "Device Manager" button.
4. Click the plus sign (+) next to "Universal Serial Bus Controllers"
Installation
EN
15 15