nanoosi WQP6-3603A S Instruction Manual page 2

For detailed operating method read the corresponding content on the instruction manual.
Switch on the appliance
Fill the detergent dispenser
Check the rinse aid level
Load the baskets
Select a programme
Running the dishwasher
Changing the programme
Add forgotten dishes in the
dishwasher.
If the appliance is switched
off during a wash cycle.
Switch off the appliance
Turn off the water tap,
unload the baskets
Press the Power switch button to switch on the appliance, Open the door.
Compartment A:
For each wash cycle.
Compartment B:
For programs with pre-wash only.
(Follow the user instructions)
Mechanical indicator C.
Electric indicator on control panel (if provided).
Scrape off any large food particles. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door, Press the program button until the selected program lights up.
"
( See the section entitled Operation instruction )
Turn on the water tap and press the Start/Pause button. The machine will start working
after about 10 seconds.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If in this case, the detergent
dispenser must be refilled.
2. Press Start/Pause Button the machine will be in stand by state ,then press the Program Button more
than 3 seconds to concel the currently Program.
3. Select a new program.
4. Restart the dishwasher.
1.Press the Start/Pause button to stop the machine.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door, then press the Start/Pause button, the dishwasher will
start running again after 10 seconds.
If the appliance was switched off during a wash cycle, when switch
on again, please re-select the washing cycle and operate the dishwasher from the beginning.
When the working cycle is finished, the buzzer of the dishwasher will sound 8 times, then stop.
Turn off the appliance using the Power button.
Since the appliance is standing by, it will power off automaticly after 30 minutes without any operation.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid scald,
as the dishes and utensils are still hot and more susceptible to break.
They also could dry better.
"
Open the door carefully.
Hot steam may escape
when the door is opened!
C
B
A