Unloading The Dishwasher - nanoosi WQP6-3603A S Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

You can modify the washing program, If the dishwasher just worked for a

short time. Otherwise, the detergent may have already been released,

and the appliance may have already drained the wash water. In this case,

the detergent dispenser must be refilled (see the section entitled "Detergent " ).

Press Start/Pause Button more than three seconds the machine will be in stand

by state, then you can change the program to the desired cycle setting(see

the section entitled " Starting a wash program ).

The program lights show the status of the dishwasher:

a) One of the program lights on----------stand by or pause.

b) One of the program lights blinking----- running.

If you open the door during washing, the machine will pause. When you close the door

and press the start/reset Button, the machine will keep on working after 10 seconds.

A forgotten dish can be added any time before the detergent cup opens.

Press the start/pause button.

Open the door a little to stop the washing.

After the spray arms stop working, you can open the door

completely.

When the working cycle has finished, the buzzer of dishwasher will sound 8 seconds, then stop. Turn off

the appliance using the Power button, shut off the water supply and open the door of the dishwasher.

Wait a few minutes before unloading the dishwasher to avoid scald, the dishes and utensils are still hot

and more susceptible to breakage. They will also dry better.

Switch Off the Dishwasher

1.Switch off the dishwasher by pressing the

2.Turn off the water tap.

Open the door carefully.

Hot dishes are sensitive to knocks. The dishes should be allowed to cool down around 15 minutes

before removing from the appliance.

Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they

will be cooler and the drying will be improved.