Operation; First Use - Zanussi zfx51400wa User Manual

• Adequate air circulation should be around
the appliance, lacking this leads to overheat-
ing. To achieve sufficient ventilation follow
the instructions relevant to installation.
• Wherever possible the back of the product
should be against a wall to avoid touching or
catching warm parts (compressor, condens-
er) to prevent possible burn.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
Service
• Any electrical work required to do the servic-
ing of the appliance should be carried out by
a qualified electrician or competent person.

Operation

Switching on
Insert the plug into the wall socket.
Turn the Temperature Regulator to the Full
Loaded position and let the appliance run at
least 4 hours to allow the correct temperature
to be reached before placing food inside.
Adjust the Temperature Regulator according to
the quantity of the stored foods.
C
A Temperature Regulator
B Half Loaded position

First use

Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and some neutral soap so
4
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation materi-
als. The appliance shall not be discarded to-
gether with the urban refuse and rubbish. The
insulation foam contains flammable gases: the
appliance shall be disposed according to the
applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit,
especially at the rear near the heat exchanger.
The materials used on this appliance marked
by the symbol
C Full Loaded position
Switching off
To turn off the appliance, turn the Temperature
Regulator to the "OFF" position.
Temperature regulation
The temperature within the appliance is con-
trolled by the Temperature Regulator situated
on the side of the appliance.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward low-
A
er settings to obtain the minimum coldness.
• turn the Temperature Regulator toward high-
er settings to obtain the maximum coldness.
B
In case of freezing less food volumes, the
Half Loaded setting is the most suitable.
In case of freezing much food volumes, the Full
Loaded setting is the most suitable.
as to remove the typical smell of a brand-new
product, then dry thoroughly.
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
are recyclable.
www.zanussi.com