Table of Contents
Advertisement
Routine Maintenance
3.8
Bulb Replacement
Please Note:. Before attempting to replace any faulty bulbs on the
vehicle, the ignition should be switched off.
3.9
Interior Light Bulb Replacement
Insert a screwdriver behind the lens of the interior light and position a rag behind
the screwdriver to safeguard against marking the trim surround. Lever the unit out
to reveal the bulb. Replace the bulb (for the correct bulb see page 46). Place the
assembly back into the aperture and push back into position.
3.10 Sidelight Bulb Replacement
Access to all the front light clusters is gained by firstly removing the upper engine
panel. There are 4 x 13mm nuts and two ball joints which secure the panel to
the vehicle. Remove the 13mm nuts first. Then unclip the 2 ball joints which
are located at the rear outer edges of the panel. Once all fastenings have been
released the bonnet panel can be removed.
Please Note: Two people will be needed to remove the bonnet panel, one
on each side of the vehicle.
43
Sidelight Bulb Replacement cont.
Next remove the inner wing access panel which is secured by 2 Self Tapping
screws. Then unclip the bulb from its mounting, disconnect and replace bulb
(for the correct bulb see page 46) Refit the bulb and replace access panel and
bonnet panel.
3.11 Headlamp/Main Beam Bulb Replacement
Access to the Headlamp bulb can be gained in the same way as with the
sidelight bulbs. Once this has been done, locate the bulb, remove the rubber
boot, disconnect the wires, unhook the spring retaining clip and remove the bulb.
Replace the bulb, refit the spring clip and the access panel.
(for the correct bulb see page 46)
3.12 Indicator Bulb Replacement
Access to the Indicator bulb can be gained by opening the minor bonnet. The
indicator is located in the front grill of the Tuscan. To change the bulb, push and
rotate anti-clockwise and the bulb can be removed.
Routine Maintenance
44
Hide quick links:
Advertisement
Table of Contents
