Table of Contents
Advertisement
Instrumentation
2.17 Gear Lever
Always select neutral before starting the engine. To engage reverse gear smoothly,
we recommend that you select fifth gear and then pull back into reverse.
WARNING: Only engage reverse whilst the car is stationary.
2.18 Door Mirror Adjustment/Demist
C
The Door Mirror Adjustment/Demist control panel is located on the drivers door.
This panel controls both the movement of the door mirror as well as the demist
function.
To adjust the position, first select the mirror to be adjusted by pushing either of
the two small buttons (A). Switch to the left button to adjust the left hand side
door mirror or to the right button to adjust the right hand side door mirror. Swivel
the central button (B) to move the mirror until the required position is achieved.
To activate the demist function simply depress the button(C) once. A red LED will
illuminate to indicate this function is active.
Please Note: The demist function will activate for 3 minutes.
To lock - press both left & right mirror select buttons.
To unlock - Press & hold the desired mirror button.
Please note: When the ignition is activated the mirrors lock.
21
B
A
2.19 Handbrake
To apply the handbrake pull the handle upwards while depressing the button at
the end of the lever. Release the button at the end of the lever's travel. When the
lever is in this position the rear brakes are on. To release, press the button and
lower the lever to its lowest position. A warning light on the dashpod will illuminate
when the handbrake is on.
Please note that it is inadvisable to use the handbrake after severe
track use until the brakes have cooled down. Please also note that we
recommend leaving the car in gear, turning the wheels towards the kerb
and pulling the handbrake on fully after fast road use as the handbrake
can slacken slightly as the brakes cool.
2.20 Immobiliser Disarm Socket
On entering the vehicle, the contact key should be inserted into the override key
socket mounted to the left of the dash pod. The small LED will be flashing to show
the vehicle is immobilised. On insertion and removal of the contact key, the LED
will be extinguished. The vehicle can now be started.
Note: The above is only for use when there is a fault with the key fob (if
immobilised switch ignition on, and press the button on the key fob).
Instrumentation
22
Hide quick links:
Advertisement
Table of Contents
