COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
SCD-XE597 SECTION 1 SERVICING NOTES HOW TO OPEN THE DISC TRAY WHEN POWER SWITCH MODEL IDENTIFICATION TURNS OFF – Back Panel – Insert a tapering driver into the aperture of the unit bottom, and turn in the direction of arrow.
SCD-XE597 SECTION 2 GENERAL This section is extracted from instruction manual. Front Panel A POWER switch (9) J X button (9) B SA-CD/CD button (5, 9) K H button (9, 12, 13, 14) Each time you press the button while playing back...
Page 5
SCD-XE597 A CD1/2 (command mode) switch (8) Remote Select the command mode. B CONTINUE button (13, 14) Press to resume Continuous Play from Shuffle Play or Program Play. SHUFFLE button (13) PROGRAM button (14) C TIME/TEXT button (11) Each time you press the button, the playing time of the track, the remaining time of the disc, or TEXT information appears in the display.
SCD-XE597 SECTION 3 DISASSEMBLY • This set can be disassembled in the order shown below. • The dotted square with arrow ( ) prompts you to move to the next job when all of the works within the dotted square ( ) are completed.
SCD-XE597 SECTION 5 • IC Block Diagrams TEST MODE – MAIN Board – IC701 M51957BFP-600C IC702 BR9040F-WF2 1. Setting Methed of Test Mode 4. Key Check Press three buttons m , [PUSH ENTER] and [POWER] simulta- Procedure: neously, The test mode becomes active. Then all segments of the 1.
SCD-XE597 Ver. 1.3 SECTION 6 EXPLODED VIEWS NOTE: • -XX and -X mean standardized parts, so they • The mechanical parts with no reference The components identified by mark 0 or may have some difference from the original number in the exploded views are not supplied.
SCD-XE597 SECTION 7 ELECTRICAL PARTS LIST DISPLAY NOTE: • Due to standardization, replacements in the • RESISTORS When indicating parts by reference number, parts list may be different from the parts All resistors are in ohms. please include the board name.
Page 33
SCD-XE597 AEP Model UK Model SERVICE MANUAL Ver. 1.2 2005.05 SUPPLEMENT-1 Subject: TEST MODE and ELECTRICAL ADJUSTMENT 9-879-005-81...
Page 34
SCD-XE597 SECTION 1 TEST MODE 1. DIAG MODE of The Test Mode While press [MENU] and [PUSH ENTER] buttons, press the [POWER] button to turn the power on and enter the Test Mode and display “DIAG MODE”. 2. Operating The Test Mode Procedure: 1.
Page 35
SCD-XE597 SECTION 2 ELECTRICAL ADJUSTMENTS GENERAL DESCRIPTION Procedure: 1. Press the Z button. After parts to the circuit (OPTICAL PICK-UP (DBU-3), RF BOARD, MAIN BOARD, EEPROM (IC702), MASTERCOM 2. Insert SACD hybrid disc (market disc). (IC705), DSP (IC706), so on) are replaced, readjusting is necessary.
SCD-XE597 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2004.06...