Getting Started - Kenwood kdc-u31r Instruction Manual

GETTING STARTED

1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: "CANCEL" \ "DEMO" \ "PRESS" \ "VOLUME" \ "KNOB"
1
Press the volume knob.
[<Y>/N] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [SETTINGS], then press the knob.
3
Turn the volume knob to select [CLOCK], then press the knob.
4
Press the volume knob to select [CLK ADJ].
5
Turn the volume knob to adjust the hour, then press the knob.
6
Turn the volume knob to adjust the minute, then press the knob.
Press 4 / ¢ to move between the hour and minute adjustment.
7
Press and hold to exit.
(or)
Press and hold SCRL DISP to enter clock adjustment mode directly
while in clock display screen.
5
Then, perform steps and
4
6
above to set the clock.
3
Set the initial settings
1
Press SRC to enter [STANDBY].
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to select [INITIAL], then press the knob.
4
Turn the volume knob to make a selection (see the table below), then press
the knob.
5
Press and hold to exit.
• To return to the previous hierarchy, press
PRESET TYPE NML: Memorizes one station for each preset button in each band (FM1/ FM2/
FM3/ MW/ LW). ; TYPE MIX: Memorizes one station for each preset button regardless of
the selected band.
KEY BEEP BEEP ON: Activates the keypress tone. ; BEEP OFF: Deactivates.
RUSSIAN RUS ON: Folder name, file name, song title, artist name, album name are displayed in
Russian (if applicable). ; RUS OFF: Cancels.
OFF WAIT Applicable only when the demonstration mode is turned off.
Sets the duration when the unit will automatically turns off (while in standby mode)
to save the battery.
OFF ––– : Cancels ; OFF 20M: 20 minutes ; OFF 40M: 40 minutes ;
OFF 60M: 60 minutes
AUX SET AUX ON: Enables AUX in source selection. ; AUX OFF: Disables. (➜ 7)
CD READ CD READ 1: Automatically distinguishes between audio file disc and music CD. ;
CD READ 2: Forces to play as a music CD. No sound can be heard if an audio file disc is
played.
SWPRE SWPRE R/ SWPRE SW: Selects whether rear speakers or a subwoofer are connected to the
line out terminals on the rear (through an external amplifier).
SPEAKER SP OFF/ SP 5/4/ SP 6 × 9/6/ SP OEM: Selects according to the speaker size (5 inches
or 4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance.
F/W UP
F/W xx.xx <Y>/N: Starts upgrading the firmware. ; Y/<N>: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
.
Default: XX