Caring For Your Machine; Replacing Moving Cutter, Disengaging Moving Cutter; Removing Face Cover - Reliable DREAMSTITCHER 600SO Instruction Manual

Table of Contents

3. CARING FOR YOUR MACHINE

REPLACING MOVING CUTTER

Replace a moving cutter if it becomes blunt as follows. A spare cutter will be found in your accessories.

NOTE:You should not need to replace fixed cutter, which is made of special hard alloy material.

FIRST REMOVE THE POWER PLUG FROM THE SUPPLY SOCKET-OUTLET.

1. Loosen screw and take out moving cutter.

2. Close the working table. Lower cutter driving

arm to its lowest position by turning the hand

wheel towards you by hand. In this position,

set replacement cutter in position and

secure it with screw, ENSURING THAT THE

EDGE OF THE MOVING CUTTER IS

APPROXIMATELY 0.5 MM BELOW THE

SURFACE OF THE FIXED CUTTER.

DISENGAGING MOVING CUTTER

If you want to sew without cutting, open the

working table and disengage the moving cutter

by pushing the cutter release knob to the left and

turning it towards you as illustrated.

Ensure that fabric edge is not wider than

overedge width selected or upper looper and

needle can be damaged.

Disconnect from power supply before removing

face cover.

Remove the screw and take off the face cover.

Table of Contents