Husqvarna MS 355 Operator's Manual page 17

Electric Models (FIG. 5):
• Install the Water Pump (U) by plugging its Electrical
Cord (NN) into the electric motor pigtail cord. Install the
on the hose. Route hose & electrical cord above
cross-brace of the Pan Weldment (B) to avoid contact
with the blade during operation and so that the splash
curtain can be easily installed (NOT as shown in Figure
5). Place the Electric Water Pump (U) in the bottom
of the Pan Weldment (A). Hook the top of the Splash
Curtain (MM) over the head pivot bar, & place the
bottom of the Splash Curtain (MM) in the pan
(Fig. 1).
• Single phase masonry saw motors are furnished with
the correct configuration Plug (OO) on the
motor pigtail. The matching connectors are as fol
lows:
Electric Motor Plugs & Connectors
Wired For
Motor
Voltage
1-1/2 HP 115 V
2 HP 230 V
3 HP 230 V
2 HP 230 V
*NEMA No.
To change operation to either 115, or 230 V, the 1-1/2
one of the 2 HP motors have a voltage change switch
mounted on the terminal box. This switch must be changed
to either 115, or 230 Volt, to match the voltage supply. Local
electrical codes may require changing the plug on the
motor to the proper connector to match the voltage supply.
Motor Pigtail Connector
Plug Required
L5-20P* L5-20R*
L6-15P* L6-15R*
L6-30P* L6-30R*
Australian AU1-10P
AS/NZS 3112
WARNING: Always make sure the saw is
connected to a properly grounded electrical
outlet. Failure to comply with this warning
could result in serious bodily injury or death!
h t e
WARNING: DO NOT operate on low voltage!
Low voltage causes loss of power, motor
overheating, and possibly motor winding
burnout. Voltage should be checked at the
motor while it is operating.
Good motor performance depends on proper voltage.
Extension cords that are too long and / or too small reduce
the voltage to a motor under load. Use extension cords NO
SMALLER than the sizes indicated in the chart shown:
EXTENSION CORD SIZE (A.W.G. Minimum)
-
Motor
HP
1-1/2 HP
2 HP
3 HP
Gasoline Model (Fig. 6):
• Install the hoses to the water pump. They must be
connected together as shown in the parts list section of
this document. Place the Strainer (S) in the bottom of
the Pan Weldment (A) after connecting the hose. Hook
the top of the Splash Curtain (MM) over the head pivot
a n d
bar, & place the bottom of the curtain in the pan
(FIG. 1).
• When the unit is fully assembled, but before starting
the engine, verify that the engine does NOT exceed 20
degrees angle of inclination in any position of the Head
Platform [Use an angle measuring gauge (customer
CAUTION: Engine inclination angles greater
than 20 degrees could cause severe engine
damage and void your engine warranty!
50 ft Long 75 ft Long
115 V 230 V 115 V 230 V 115 V 230 V
#10 #14 #10 #14
#10 #12 #10 #12
--- #10 --- #10
100 ft Long
#10 #14
#10 #12
--- #10
17