Instructions For Reversing Door Swing - LG GC-B379S*QA Service Manual

INSTRUCTIONS FOR REVERSING DOOR SWING

This refrigerator allows the owner to change the door swing if desired.
The hinging of the doors can be changed to the opposite side
anytime you wish.
A Warning Electric Shock Hazard Disconnect electrical supply to
refrigerator before installing. Failure to do so could result in death or
serious injury.
When reversing the door swing :
• Read the instructions all the way through before starting.
• Handle parts carefully to avoid scratching paint.
• Set screws/bolts down by their related parts to avoid using them in
the wrong places.
• Provide a non-scratching work surface for the doors.
IMPORTANT
Once you begin, do not move the cabinet until door-swing reversal is
completed.
These instructions are for changing the hinges from the right side to
the left side-if you ever want to change the hinges back to the right
side, follow these same instructions and reverse all references to left
and right.
Before Removing the Doors, empty and Remove all the Door Baskets
of both Refrigerator/ Freezer Doors, including the Bank Dairy.
Close both doors before removing hinge pins.
CAUTION
Do not let either door drop to the floor.
Doing so could damage the Door Stop.
How to Reverse the Door
1. After unscrewing the screw (2) of cover hinge (1) on the
top, take off cover hinge and disconnect cable (5) (Only for
the exterior display type models). Unscrew bolts (3), which
fasten upper hinge (4) and remove upper hinge (4). Carefully
take off the refrigerator's door (A).Remove cap (6).
6
A
2. Remove cap cover of door (7) (only for the exterior display
type models), pull out cable (5) and install it into the opening
on the opposite side of the door.
Set the cap cover of door (7) in its place.
2
1
3
5
4
7
A
3. Screw out the screw (8) located under the refrigerator
door (A) and move it emphasis (9) to the opposite side.
Fixate the screw.
4. Move plastic caps (10) (for all types display) and (11) (only
for of interior type display models) to the opposite side.
6
5. (Only for exterior type display). Press by the (-)
screwdriver and separate caps (12) of cover front (13) and
unscrew screws (14), remove cover front (13), then move
cable (5) to the opposite side. After installation cover
front (13), screw by parts (14) and cover it by caps (12).
7
11
5
9
8
10
5
13
12
14