Explanation Of Each Process - LG wm2016cw Service Manual

5-4. EXPLANATION OF EACH PROCESS

No. Process
1. Stay • Electrical power is supplied
• Washer is ready to work and the micom is in the active mode.
2. Water • After loading laundry and selecting a course and a cycle, water is
supply
• When a user selects Pre-wash course, water is supplied through
3. Soaking • To get laundry wet, drum rotates clockwise and counterclockwise.
& washing • If water amount is insufficient at this time, the Inlet valve will supply
laundry
4. Washing • Fuzzy Logic decides washing time according to the laundry load, water
5. Drainage • A pump motor drains the water from the drum.
• After sensing drained water amount by water level frequency, spin starts.
• When a heating course is selected, stay cooling process is performed to
6. Untangling • It balances laundry load and senses the eccentricity of the load, to only
(Sensing
eccent- • If the eccentricity is worse than the allowed level, it repeats the
ricity)
• If the eccentricity is good, the intermittent spin starts.
• During this process, the drain pump works for drainage intermittently.
supplied and drum rotates.
pre wash valve.
water again.
temperature, and other factors.
decrease the water temperature gradually to prevent laundry from being
damaged and for safety reasons.
allow spinning without vibration
disentangling process. When the repeated time is more than allowed
level, it displays UE.
Explanation
15