Camera Functions On The Ccs; Navigation Functions On The Ccs; Settings In The Main Menu - Bosch CCS Operating Instructions Manual

Monitor settings | Camera functions on the CCS | Navigation functions on the CCS
64 | en

Settings in the main menu

1 Menu level
st
:
MON ON/OFF/
SYNC

Camera functions on the CCS

Note:
The following function is only
available if a camera is connected to
an appropriately configured driver's
monitor.
Function
Display the camera
image on the driver's
monitor

Navigation functions on the CCS

Notes:
The following functions are only
f
available if a suitable navigation
system is connected.
As long as the navigation system
f
is set as the source, the focus of
control will be set to the
navigation system and the
display will indicate "NAVI".
09.2014
Function
Activate/deactivate/synchronise monitors in the cabin
Action
f Briefly press the
CAM button H
Note
If more than one camera is connected, you can
switch through the images from the various
cameras by repeatedly pressing the CAM
button H.
When the last camera image is displayed, you
can return to the display of the current audio/
video source by pressing the CAM button H.
You can control the navigation
system using the remote buttons
> and the ENTER button F.
If, during this time, you switch
the focus of control over to the
cockpit or cabin, the focus of
control will return automatically
to the navigation system approxi-
mately 10 seconds after your
last button press.
Robert Bosch Car Multimedia GmbH