Hardware Setup - Salient Technology V-Mouse VM-203 User Manual

STI2006-2x3ML-v1p2

HARDWARE SETUP

A. Charging Up the Battery
For safety reasons, the battery was partially charged in the factory before
packing. You should fully charge up the battery before using the device
the first time.
1. Insert Connector B of the USB Charging Cable into the Battery
Charging Jack.
2. Insert Connector A of the USB Charging Cable into a USB port.
When the battery is charging the Battery Status Light stays on.
3. Wait until the Battery Status Light turns off and remove the USB
Charging Cable. The normal charging time should be 2 to 3 hours
if a dedicated USB port is used. Charging time will be longer if a
non-powered USB hub is used. (Remark B)
4. Repeat Steps 1 to 3 when the battery is flashing. You can keep on
using the device during charging; however, the charging time will
be extended. (Remark C)
B: Use a dedicated USB port or a powered USB Hub for fastest charging.
Remark
C: Lithium batteries do not have memory effect and can be partially
Remark
charged.
B. Installing the Device
1. Turn on your computer, if it is not already on.
2. Turn on your V-Mouse by pressing down both the left button and
the right button for 10 seconds, if it is not already on. (Remark D)
3. Connect the Dongle Receiver to a USB port. A message "wireless
pen mouse (2.4 GHz)" should appear on your computer screen.
Allow the automatic set up process to complete and the messages
to disappear. (Remark E)
4. Press down the Channel Select Button A on the Dongle Receiver
once and the Transmission Status Light should start flashing.
5. Hold down the Channel Select Button B and press down the Right
Mouse Button once and then release both buttons. Wait for the
Transmission Status Light to turn off, the installation is
completed.
6. After the first successful installation, your Dongle Receiver and
V-Mouse are permanently matched. You DO NOT need to repeat
Steps 4 and 5 even when you take your V-Mouse to a different
computer.
7. Repeat steps 4 and 5 to re-establish the transmission channel
setting when needed.
D: For safety reasons, your V-Mouse was shipped with the power turned
Remark
off. Please turn on the power before using it the first time.
E: The series of messages will appear on each computer only once,
Remark
when it receives the V-Mouse dongle the first time.
8/97