Product Care - Salient Technology V-Mouse VM-203 User Manual

STI2006-2x3ML-v1p2
battery usage. If it stays idle for more than a second, the LED dims and
the V-Mouse goes into Stage One Power Save Mode. In Stage One, the
motion sensor and the buttons remain operational. If the V-Mouse
remains idle for 5 minutes in Stage One Power Save Mode, the LED starts
flashing and the V-Mouse enters Stage Two Power Save Mode. In this
mode, the motion sensor and the buttons remain operational.
If the V-Mouse remains idle for 60 minutes in Stage Two Power Save
Mode, the LED turns off and the V-Mouse enters Stage Three Power
SaveMode. In this mode the motion sensor is turned off but the buttons
remains operational. (Remark G)
G: Clicking the mouse button in any Power Save mode will bring the
Remark
V-Mouse to the normal Mouse Mode immediately.
D. Turning Power On/Off
To turn off the power of the handheld unit, press down the Left Button
and the Right Button at the same time for 10 seconds and wait for the
Blue LED to turn off.
To turn on the power of the handheld unit, press down the Left Button
and the Right Button at the same time for 10 seconds and wait for the
Blue LED to turn on.
You DO NOT have to reinstall the device or reset the communication
channel between the handheld device and the receiver after turning off
the power.
E. Using the Laser Presenter Function [VM-223]
Hold down the Channel Select Button B and press down the Laser Pointer
Button once will put the V-Mouse into the Presenter Mode. In the
Presenter Mode, the Blue LED is turned off, the Right Button becomes the
Page Up button, and the Left Button becomes the Page Down button.
Hold down the Channel Select Button B and press the Laser Pointer
Button once again will switch the V-Mouse back to the Mouse Mode.
For safety reasons, the VM-223 comes with an automatic Laser Shut-off
function. The Laser Pointer will automatically turn off when the laser
button is pressed down for 4 minutes.
To avoid confusion, the VM-223 returns to the Mouse Mode when the
device is unattended for 1 hour in the Presenter Mode.

PRODUCT CARE

There are no user-serviceable parts in this product and you should not
disassemble it under any circumstances without proper training/
authorization. Following the safety guidelines in the Safety Caution
Section and this product should last for a long time. Occasional cleaning
with a slightly damped soft towel on the outside will help keep its
appearance in good condition.
10/97