Headphone; How To Operate The Headphone - Beyerdynamic RSX 700 Operating Instructions Manual

Audio Connection
• Connect the supplied audio cable and adapter cable to the audio input
socket of the transmitter and preferably to the phono/RCA sockets of
your audio source/hi-fi system.
Important: Ensure that the polarity of the phono/RCA connectors is
correct, i.e. right to right (red) and left to left (white).
• As an alternative you can use the headphone output (mini jack 3.5 mm;
6.35 mm (1/4") jack by using an appropriate adapter) of your audio source/
hi-fi system. Please note that in this case the volume must be turned up
sufficiently.
Connect the transmitter to a TV set or hi-fi system via RCA
Connect the transmitter to a CD or MP3 player via mini jack
(3.5 mm)
Volume of the CD or MP3
player must be turned up
sufficiently
Connect the transmitter to a hi-fi system via 1/4" jack (6.35 mm)
Volume of the hi-fi system
must be turned up
sufficiently
Switching on
• Switch on the audio source to which the transmitter is connected. When
the transmitter receives a signal, the red Power On LED
Attention:
• If the transmitter does not receive any signal, it will automatically
switch off after approximately 3 minutes and the Power On LED
will go out.
• If the transmitter receives a signal again, it is turned on automatically. The
channel display , however, always indicates "0".
18
2.
Controls and Indicators
Connect the cable to
the audio input of the
µ On/Off button
transmitter
¸ Power on LED will illuminate green when the headphone is turned on;
¹ Charging socket to connect the charging cable to the left hand side
2.1
Connect the cable to
the audio input of the
transmitter
How to insert/replace the Batteries
• Turn the left ear cup clockwise and remove it
• Insert the rechargeable batteries (AAA size,
• If you use other rechargeable batteries instead
Connect the cable to
the audio input of the
transmitter
• Instead of rechargeable batteries you use normal
will illuminate.
• Replace the left ear cup and turn it anti-clockwise by pressing slightly onto

Headphone

µ ¸
Button to increase the volume of the headphone
Channel button to scan and set the receiving frequency
automatically to the frequency of the transmitter
Button to reduce the volume of the headphone
when charging it will illuminate red
Battery compartment to insert the rechargeable batteries into the left ear
cup

How to operate the Headphone

by pulling slightly.
1.2 V) according to the "+/-" symbols into the
appropriate compartments .
Attention: The rechargeable batteries must be
charged before the first use (refer to chapter
3. "Charging of rechargeable Batteries").
of those supplied by beyerdynamic, you must
remove a bit of the plastic jacket at the
negative pole by using a knife or something
similar to ensure contact to the lateral charging
contacts inside the battery compartment.
dry cell batteries.
Warning: Do not remove the plastic jacket of normal dry cell batteries,
as there could be danger of explosion, if you try to charge by mistake!
the ear cup until it locks into place.
Important: Use the padlocked symbols as a location guide when the
ear cup is replaced.
¹
19