Flame Effect; Heating Unit; Thermostat Operation; Thermal Safety Cut-Out - Faber Varda Installation And Operating Instructions Manual

EN

5.2 FLAME EFFECT:

Press L switch to the 'ON' position (a switch
is in the "ON" position when the red indicator
mark on the switch is visible). The flame effect
will now operate.
fig. 13

5.3 HEATING UNIT

You have a choice of low heat 900 W or high heat 1800 W
output. Both settings have thermostat temperature control. In
order to operate the heating, switch L must be in the 'ON'
position (see fig. 13).
5.3.1 Low Heat Setting
With switch L in the 'ON' position, press switch '
5.3.2 High Heat Setting
With switches L and ' ' in the 'ON' position, press Switch '
to 'ON'. The 1800W heat output is controlled by the thermostat,
which should be set to maximum (see 'thermostat operation').
8

5.4 THERMOSTAT OPERATION

fig. 14
0
6
' to 'ON'.
5
4
fig. 15
'

5.5 THERMAL SAFETY CUT-OUT

The thermostat controls the heat output according to the room
temperature. This ensures that the heater will not produce heat
unnecessary when the room is warm.
IVAR/ALMA
To set the temperature you require, turn the thermostat knob
fully clockwise to 'max' position. When the room is warm
enough, turn the knob back slowly until the thermostat just
clicks off. The heater will now maintain your selected
temperature (fig. 14).
Note: Once the thermostat has switched the appliance off it
may take some time before the heater comes back on. This
does not mean that the appliance is faulty.
VARDA/NARVIK/OTHELLO
The thermostat regulates the heat output according to user
needs. To set the temperature you require, turn the temperature
1
knob to position 3. If after a period of time you require more
heat turn the knob to position 3. If after a period of time you
2
require more heat turn the knob to a higher setting, or further
3
reductions in heat output may be obtained by turning the knob
to lower settings (fig. 15).
A thermal safety cut-out is incorporated in the heater to prevent
damage due to overheating. This can happen if the heat outlet
was restricted in any way. The heater will switch on once the
obstruction has been removed and the heater has cooled. If the
cut-out continues to operate intermittently, the heater should be
switched off and a service agent contacted.
EN
9